Does anyone have one of these? I’m just looking for some measurements on it to see the maximum sidewall I could use these on.
Thanks!
Sent from my iPhone using Tapatalk
SSbrewtech 1.5” TC Bulkhead Compression fitting
- oceanic_brew
- Verified User
- Posts: 625
- Joined: Wed Aug 26, 2015 6:14 pm
- Name: Glen O'Keefe
- EastCoastHoppers
- Vendor
- Posts: 192
- Joined: Wed Sep 13, 2017 7:42 pm
- Name: Matt
- Location: Charlottetown PEI
- Contact:
Re: SSbrewtech 1.5” TC Bulkhead Compression fitting
I don't have any of these in stock myself so I wasn't able to do any measuring for you but I did reach out to one of my contacts at SS Brewtech and asked them this. Here is their reply:
"For these compression bulkheads they need a fairly thin surface to work off of, typically 5mm or less. Our Fermenters/kettles that these were designed for are about 1mm-1.5mm thick depending on the model."
Hope that helps!
Cheers,
Matt
"For these compression bulkheads they need a fairly thin surface to work off of, typically 5mm or less. Our Fermenters/kettles that these were designed for are about 1mm-1.5mm thick depending on the model."
Hope that helps!
Cheers,
Matt
Visit us online at: https://eastcoasthoppers.ca
Follow us on FaceBook at: https://www.facebook.com/EastCoastHoppers/
Follow us on Twitter: https://twitter.com/Eastcoasthopper
Follow us on Instagram: https://www.instagram.com/eastcoasthoppers/
Follow us on FaceBook at: https://www.facebook.com/EastCoastHoppers/
Follow us on Twitter: https://twitter.com/Eastcoasthopper
Follow us on Instagram: https://www.instagram.com/eastcoasthoppers/
- oceanic_brew
- Verified User
- Posts: 625
- Joined: Wed Aug 26, 2015 6:14 pm
- Name: Glen O'Keefe
Re: SSbrewtech 1.5” TC Bulkhead Compression fitting
Thanks! I reached to them too but they said they weren’t near them to actually measure what they were capable of. I have one that’s for a similar size but it actually unscrews quite a bit
Who is online
Users browsing this forum: No registered users and 46 guests