Just finished building my control panel. I've noticed, though, that all 3 of my controllers seem to settle out 1 to 2 degrees higher than the set point. Any thoughts as to why this would be the case? It's not a huge deal, I can compensate by setting 1 degree lower to what I want. It just seems odd.
Thanks.
Mypin Controllers
-
- Verified User
- Posts: 39
- Joined: Fri Mar 14, 2014 9:18 am
- Name: Bill
-
- Award Winner 1
- Posts: 43
- Joined: Fri Jan 13, 2012 4:15 pm
- Name: Mark Power
- Location: Elmsdale, NS
Re: Mypin Controllers
Have you ran an auto tune on the PID? I use a Sestos PID and after tuning, it is usually dead on the set point. Make sure to run the auto tune with as close to your actual brewing parameters as possible.
-
- Verified User
- Posts: 39
- Joined: Fri Mar 14, 2014 9:18 am
- Name: Bill
Re: Mypin Controllers
Yeah I ran the autotune on 2 of the 3 controllers so far. Maybe I'll run them again, this time closer to my set point. I think I turned autotune on 5 or 7 degrees below set point.
Who is online
Users browsing this forum: No registered users and 11 guests