Page 1 of 1
Help drilling kettle (cole harbour/dartmouth)
Posted: Tue Jan 16, 2018 8:33 pm
by wader98
Just received a new 10 gallon kettle today and looking for some help drilling 2 holes. One for ball valve and the other for element. My step bits are not big enough...
Can offer $ or coffee...no drinkable beer yet!
Re: Help drilling kettle (cole harbour/dartmouth)
Posted: Wed Jan 17, 2018 9:13 am
by GAM
What sizes?
S
Re: Help drilling kettle (cole harbour/dartmouth)
Posted: Wed Jan 17, 2018 11:56 am
by wader98
Need 13/16 (21mm) for the ball valve and 1 and 1/4 for the element.
Re: Help drilling kettle (cole harbour/dartmouth)
Posted: Wed Jan 17, 2018 12:03 pm
by GAM
I have a 1.25" punch and 3/4" drill (you will need to drem out the hole to fit).
Sandy
Re: Help drilling kettle (cole harbour/dartmouth)
Posted: Wed Jan 17, 2018 8:50 pm
by wader98
GAM wrote: ↑Wed Jan 17, 2018 12:03 pm
I have a 1.25" punch and 3/4" drill (you will need to drem out the hole to fit).
Sandy
Hey Sandy, I'll take you up on that offer. Obviously tonight is shit but I'm available any other time. Let me know what works best for you. Thanks again.
Re: Help drilling kettle (cole harbour/dartmouth)
Posted: Wed Jan 17, 2018 11:17 pm
by GAM
Early Friday or Sunday.
S