Page 1 of 1
Introducing Boris...
Posted: Fri Feb 05, 2016 9:16 pm
by jtmwhyte
Re: Introducing Boris...
Posted: Fri Feb 05, 2016 9:26 pm
by LeafMan66_67
Looking great!
Re: Introducing Boris...
Posted: Fri Feb 05, 2016 9:42 pm
by RubberToe
Nice!
Re: Introducing Boris...
Posted: Fri Feb 05, 2016 10:06 pm
by jtmwhyte
The hot pod from brew hardware is a nice little piece of equipment. I only wish I'd ordered before the Loonie hit the skids
Re: Introducing Boris...
Posted: Wed Feb 10, 2016 7:59 pm
by Albert
jtmwhyte wrote:The hot pod from brew hardware is a nice little piece of equipment. I only wish I'd ordered before the Loonie hit the skids
Looks slick....probably less$$ and lower profile than the electro brewery style box especially including labor??
Re: Introducing Boris...
Posted: Wed Feb 10, 2016 8:54 pm
by jtmwhyte
Albert wrote:jtmwhyte wrote:The hot pod from brew hardware is a nice little piece of equipment. I only wish I'd ordered before the Loonie hit the skids
Looks slick....probably less$$ and lower profile than the electro brewery style box especially including labor??
The first electric kettle I built used the Electric brewery DIY setup. Still use it on a mash tun 5 years or so later, but yeah... huge profile. The hotpod is tiny and super easy to install. I'm going to try it out next week sometime. HAving a hard time keeping th spigot from leaking with a flat gasket.
Re: Introducing Boris...
Posted: Wed Feb 10, 2016 11:59 pm
by sleepyjamie
What controller are you using?
Sent from my iPhone using Tapatalk
Re: Introducing Boris...
Posted: Thu Feb 11, 2016 5:36 pm
by jtmwhyte
sleepyjamie wrote:What controller are you using?
Sent from my iPhone using Tapatalk
built one from stilldragon DIY kit. I'll snap some photos