Page 1 of 1
New Tap Setup
Posted: Sat May 14, 2016 9:16 pm
by jtmwhyte
Long and short, my wife is expecting again in October and we needed to clear space out in the house. Got rid of my 4 tap fridge down to this little gem.
I had a tough time dialing in line lengths, but it's working well as if now. Got get a cozy made up to cover the hideous red co2 tank, but otherwise I'm happy with the end result
Re: New Tap Setup
Posted: Fri May 27, 2016 5:22 pm
by elreplica
Looks like a Danby 4.4... I geared one up four years back, bought the nice tower with Perlicks and never punched the hole fir them. Just ran Cobra taps until I picked up my True TDD1 (still mothballed) and my recent as new Danby 5.2 with a newly filled 20 lb. x 2 tanks. I got a corny to Sanke adapter set from Everwood Dave with new stainless corny gas and liquid connects and she's looking fine. Will post soon. Enjoy!
Re: New Tap Setup
Posted: Fri May 27, 2016 9:48 pm
by jtmwhyte
It's a Danby 4.3 with the freezer compartment folded down. I have a temp controller keeping it at 6 Celsius and co2 plumbed through the back.
I also ran pipe insulation inside the tower (aside from the tower insulation and fitted copper tubing inside that from the taps down into the fridge. Getting way less foam on initial pours than before the switch
