Page 1 of 1
LF Someone to Drill a hole in my Kettle
Posted: Fri May 22, 2020 11:33 am
by JonnyGo
Hey,
Looking to get a 1.5 inch weldless TC fitting installed on my kettle. Anyone have any contacts on who can drill the hole necessary for this?
Thanks!
Re: LF Someone to Drill a hole in my Kettle
Posted: Sun May 24, 2020 10:49 am
by oceanic_brew
Try Mariner Forge over in Dartmouth
Sent from my iPhone using Tapatalk
Re: LF Someone to Drill a hole in my Kettle
Posted: Sat May 30, 2020 5:20 pm
by RossBee
I used a bi-metal hole saw to drill all my kettles and HLT.
Re: LF Someone to Drill a hole in my Kettle
Posted: Sat May 30, 2020 5:43 pm
by jimboh
Re: LF Someone to Drill a hole in my Kettle
Posted: Sun May 31, 2020 8:22 am
by JonnyGo
Thanks for the suggestions guys!
I actually gave Mariner Forge a call and they were confident to be able to cut and weld a fitting to my kettle so I bought the ferrule (
https://www.ontariobeerkegs.com/S_S_Tri ... -1-8in.htm) from OBK and gonna give it a shot with them.
Re: LF Someone to Drill a hole in my Kettle
Posted: Sun May 31, 2020 9:44 am
by Halifax_Jeff
JonnyGo wrote:Thanks for the suggestions guys!
I actually gave Mariner Forge a call and they were confident to be able to cut and weld a fitting to my kettle so I bought the ferrule (
https://www.ontariobeerkegs.com/S_S_Tri ... -1-8in.htm) from OBK and gonna give it a shot with them.
Make sure they do a sanitary weld.
Sent from my LG-H933 using Tapatalk