SSbrewtech 1.5” TC Bulkhead Compression fitting

A spot to talk general homebrew
Post Reply
User avatar
oceanic_brew
Verified User
Verified User
Posts: 601
Joined: Wed Aug 26, 2015 6:14 pm
Name: Glen O'Keefe

SSbrewtech 1.5” TC Bulkhead Compression fitting

Post by oceanic_brew » Fri Jul 10, 2020 12:33 pm

Does anyone have one of these? I’m just looking for some measurements on it to see the maximum sidewall I could use these on.

Thanks!


Sent from my iPhone using Tapatalk

User avatar
EastCoastHoppers
Vendor
Vendor
Posts: 158
Joined: Wed Sep 13, 2017 7:42 pm
Name: Matt
Location: Charlottetown PEI
Contact:

Re: SSbrewtech 1.5” TC Bulkhead Compression fitting

Post by EastCoastHoppers » Sat Jul 11, 2020 9:09 am

I don't have any of these in stock myself so I wasn't able to do any measuring for you but I did reach out to one of my contacts at SS Brewtech and asked them this. Here is their reply:

"For these compression bulkheads they need a fairly thin surface to work off of, typically 5mm or less. Our Fermenters/kettles that these were designed for are about 1mm-1.5mm thick depending on the model."

Hope that helps!

Cheers,
Matt

User avatar
oceanic_brew
Verified User
Verified User
Posts: 601
Joined: Wed Aug 26, 2015 6:14 pm
Name: Glen O'Keefe

Re: SSbrewtech 1.5” TC Bulkhead Compression fitting

Post by oceanic_brew » Sat Jul 11, 2020 12:59 pm

Thanks! I reached to them too but they said they weren’t near them to actually measure what they were capable of. I have one that’s for a similar size but it actually unscrews quite a bit

Post Reply

Return to “General Homebrew Discussion”

Who is online

Users browsing this forum: Google [Bot] and 0 guests